DEWINNER VPID7133A Manual De Instrucciones página 8

DEWINNER HANDLE ELECTRIC DRILL is a handle electric tool with two – fold
insulation,drived by the series generation. Its features are small in volume, light in
weight, convenient to catch etc. It can be used in places which is moist and narrow.
It can be used in the workshop with good conduct electricity, such as work high
above the ground or metal frame etc.
Ⅱ. INSTRUCTION OF SAFETYUSE MAINTENANCE
Read the explanation following before the tool got through power.
SAFETY
1. Be sure to carry out strictly the relevant rules in GB 3387 THE TECHNICAL
RULESONMANAGEMENT USE CHECKING AND SAFE MAINTENANCE OF THE HAN0LE
ELECTRIC TOOLS.Otherwise you must obey our explanation first.
2. REGULARIIING WORKPIECE The workpiece to be drilled must be regularized and
pay more attention to it when it is drilled through.
3. Use the plug correctly wighout changing the plug as one please and pluging the
outlet with bare conducting wire directly not using the plug. Be sure to take off the
plug in time.
4. Not to use power wire without limited. Be sure not to lengthen or change the
power wire, not to carry the power wire touch heat source and oil. Prevent damage to
the machine.
OPERATION
1. USE ASSIGNED VOLTAGE The voltage in the circuit must be not more than 10% at the
data plate assignment before using it.
2. CHECK BEFORE BEING USED Let the tool have non loading for one minute and see
whether the function of transmission position is flexible and there is abnormal noise and the
screws become flexible and fall off and the erting sparkle is normal or not.
3.PREVENT THE TOOL FROM OVERLOAD The head of the drill must be sharp. When you
are drilling, you should not be too tough. If the rotation speed is reduced abnormally, you
should reduce to exert yourself. If the drill stops suddenly or gets stuck, you turn off the
power.
4. CHANGE THE BRUSH IN TIME If the brushes are too damaged to use, change them both
at the same time, otherwise the brushes and the inverter will be in loose contact even
sparkle around or the inverter can be damaged. Sometimes the armature would be burnt.
5.It can not be used in the following condition. If you find the insulate is damaged, the
power wire or electric cable case is broken the plug and outlet is broken, and it works
continually the sparkle appears seriously etc. you should repair immediately. It can not be
used before being repaired.
Ⅰ. FUNCTION & USE
US