Publicidad
Idiomas disponibles
Idiomas disponibles
Before using the coffee grinder, wipe the housing and Coffee bean box with a clean damp cloth. Wash the coffee powder jar and the
coffee powder jar lid in warm soapy water, then rinse and dry. Do not use it when any of the parts are wet.
Setup:
Installing the bean box:
1. Make sure the coffee grinder is unplugged.
2. Hold down the Coffee bean box release lever located on the other side of the device with the OPEN LOCK icon on the body of the
device and then locate the triangle icon on the bean box (Pic 2) line the two up and push down.
3.Then rotate the bean box clockwise until the release button clicks and the closed lock icon is lined up with the triangle on the main
body. (pic 3)
Removing the bean box:
1. First remove the beans from the box.
2. Use the attached brush and remove any remaining beans from the burr inside of the bean box. (pic. 4)
3. Press the release button on the side of the main body. The bean box should jerk to the side and the bean box will be released.
4. Pull on the box upwards to take it out of the coffee fineness ring.
Setting coffee grind size:
1.Fit the coffee powder jar and its lid in their correct positions. Check that the assembly is correctly positioned in the body.
2.Open the lid of the coffee bean box and fill the coffee bean box with desired whole coffee beans. Close the lid, you can now adjust the
coffee grind size.
3.Your coffee grinder has 31 grind size options. To adjust the grind size, rotate the coffee bean box and adjust from fine to coarse
depending of the type of coffee you are brewing. (pic. 5)
WARNING: DO NOT ADJUST THE GRINDING DURING OPERATION. IT WILL AFFECT THE COFFEE GROUND COARSENESS AND
CAN DAMAGE THE DEVICE.
FOR BEST RESULTS PLEASE CONSULT THE TABLE ON PAGE 3 OF THE MANUAL (Pic. 7)
A. CEZVE – FINE COFFEE, SETTING: 1-2
B. ESPRESSO – MIDDLE FINE, SETTING: 3-5
C. SIPHON - MIDDLE, SETTING: 6-10
D. DRIP COFFEE – MIDDLE, SETTING: 11-20
E. POUR OVER - MIDDLE COARSE, SETTING: 17-25
F. FRENCH PRESS – COARSE, SETTING: 26-31
OPERATION INSTRUCTIONS:
WARNING: Before starting the operation make sure the coffee powder jar (M) is in place and has a lid on it.
1. This unit has 3 buttons (6B:1,2,3) to control on the control panel(6A) :
6B,1: Cups – control between 1 – 10 cups of ground coffee. Pressing the button will add 1 cup each press. After 10 the counter will
return to 1.
6B,2: Timer – control between 1- 25 seconds of operation. Pressing the button will add 1 second each press. After 25 the counter will
return to 1.
6B,3: Start / Stop-Start or stop the operation.
2. Press the desired amount of cups or time( 6B,1 or 6B,2) and then press the Start / Stop button (6B,3) to start or cancel the operation.
BURR CLEANING
For cleaning please consult the pictures on page 4 of the manual.
Regular cleaning helps achieve consistent grinding results. Clean every 5 uses.
1.Unlock Bean Box
2.Remove Beans
3.Lock Bean Box
4.Run Grinder Until Empty
5.Remove Bean Box
6.Remove Upper Burr
7.Clean Upper Burr with Cleaning Brush
8.Clean Lower Burr with Cleaning Brush
9.Clean Grind Outlet with Brush
10. Push Upper Burr Firmly into Position
11.Lock Upper Burr
12.Align Bean Box into Position
13.Lock Bean Box
Maintenance:
To keep all your coffee`s aroma and to avoid degradation of the ground coffee, empty the ground coffee container after each use.
Always unplug from the power outlet before cleaning.
Never place the grinder, power supply cord, or plug in water or under running water.
Do not use strong detergents or abrasive pads to clean the appliance.
Clean the lids and the ground coffee holder in warm, soapy water.
Troubleshooting
ERROR Code:
Publicidad
