Centrosolar PowerStocc 1200 Manual De Instalación página 9

2. Installation and Setup
2
Illustration 2.4: Mounting
Illustration 2.5: Removal
2.1.2. How to Open the Inverter
Illustration 2.6: How to Open the Inverter
8
Mounting
Slide the inverter upwards until the inverter
snaps into the wall bracket top slots, and low-
er the inverter until it rests in the wall bracket
slots (1). Push the bottom end of the inverter
against the wall until the lock spring snaps in
place (2). Check that the inverter is now se-
curely fixed to the wall bracket.
Removal
Insert a screwdriver or similar into the wall
bracket side slot (1). Move the screwdriver
upwards while pulling the inverter away from
the wall until the lock spring disengages. Pull
the inverter bottom end away from the wall
(2). Slide the inverter upwards until it disen-
gages from the wall bracket and remove it
from the wall (3).
Follow the steps below to open the inverter:
1. Unscrew the screw in the DC-switch
and remove the knob.
2. Unscrew the 2 screws holding the
cover in place.
3. Pull the cover upwards.
4. Tilt and pull up and away from the
inverter.
5. Unplug the earth cable before re-
moving the cable cover.
L00410289-03_3m