Publicidad
Idiomas disponibles
Idiomas disponibles
2. Insert the plug [1] at the bottom of the jointed support into the opening in the table clamp [2].
»
Regularly check that it is securely seated.
6.2.
MOUNTING THE LAMP TO THE SCREW-ON FLANGE
Screw-on flange only for attachment to a sufficiently stable horizontal installation surface.
1. Attach the screw-on flange to the installation surface.
CAUTION! Risk of injury due to the lamp falling or toppling over.CAUTION! Install the securing elements
properly.
2. Insert the plug [1] at the bottom into the opening of the screw-on flange [3].
»
Regularly check that it is securely seated.
6.3.
MOUNTING THE LAMP TO THE TABLE BASE
Table base only for attachment to a sufficiently stable horizontal installation surface.
1. Attach the table base to the installation surface.
CAUTION! Risk of injury due to the lamp falling or toppling over.CAUTION! Install the securing elements
properly.
2. Insert the plug [1] at the bottom into the opening of the table base [3].
»
Regularly check that it is securely seated.
7.
Preparation for use
7.1.
ADJUSTING THE LAMP
NOTICE! Damage to the lamp. Do not rotate the joints contrary to their intended direction of rotation. Do
not kink the flexible neck or bend it tightly.
1. Move the LED magnifying glass lamp into the desired position by adjusting the flexible neck
2. Adjust the lamp head using the swivel joint.
7.2.
CONNECTING THE POWER
NOTICE
Wrong supply voltage
Damage to the lamp.
»
Check the power supply against the rated voltage and frequency shown on the nameplate, and ensure they are
identical.
7.2.1.
Connecting the lamp to the mains power supply
NOTICE! The attached power supply unit can also be used in the USA. To do so, exchange the plug part with
round pins for the plug with US-type flat pins supplied.
1. Connect the power supply unit to the mains.
8.
Operation
NOTICE! The lamp is fitted with a cut-out to protect it if it overheats. If the lamp cuts out because it has
overheated, first allow it to cool down before switching it on again.
8.1.
SWITCHING THE LED MAGNIFYING GLASS LAMP ON AND OFF
i
The device switches on at the last dimming level.
1. Briefly touch the On/Off sensor button to switch the lamp on.
2. Briefly touch the On/Off sensor button to switch the lamp off.
8.2.
DIMMING
1. Press and hold the On/Off sensor button.
»
After about a second, the brightness of the lamp will start to change.
www.hoffmann-group.com
de
bg
da
en
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
25
Publicidad
