Horizon Global 118882 Instrucciones De Instalación página 4

4. Beginning on the driver's side and underneath the vehicle, route the
harness containing the yellow wire up through the opening between
the vehicle bumper and body to the driver's side taillight pocket.
Note:
For ease of installation use a fish wire between taillight pocket and
rear fascia to pull harness from underneath vehicle out through the
taillight pocket.
6. Underneath the vehicle on the driver's side. Locate the black
environmental cover. Using a trim panel tool, remove the 4 plastic
clips, being carful to not damage them. Locate the 2 plastic retaining
nuts. Using a 14mm socket remove the plastic nuts and set cover
aside.
©2023 Horizon Global™ Corp
5. Locate the connectors matching the end of the T-One® Connector. Insert
the T-One® Connector end containing the yellow wire in between the
vehicle and taillight connector. All connector's surfaces should be clean
and free of dirt.
Sheet 4 of 24 118882-NP 1/20/2023 Rev. A