Publicidad
Idiomas disponibles
Idiomas disponibles
Use only VITO-approved tools and accessories for this
machine or technically identical parts. Failure to do so may
result in personal injuries or damages to the paddle mixer.
If in doubt, if you lack knowledge or resources, you should
contact an official dealer.
Your paddle mixer should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
1. Screw the bar (3) into mixing paddle head (1);
2. Insert a spanner to the mixing paddle head thread (2)
and tighten the bar with another spanner;
3. Screw the paddle bar into the spindle thread;
4. Insert a spanner to the spindle thread and tighten the
mixing paddle bar thread.
The machine is designed for mixing mortar, cement, floor
glue, plaster and paint.
When working with the paddle mixer, you should bear in
mind some use procedures:
▪ Always hold the mixer with both hands on the handles;
▪ Never switch on the mixer when the mixing paddle is
touching the materials to be mixed. The paddle must
only be placed in the bucket once the maximum rotation
speed has been reached;
▪ Work in such a way that the power cord is always kept
away from the mixer during operation.
1. Before plugging in the power cord, make sure the
"ON/OFF" switch (5) is "OFF" positioned;
2. Hold the mixer with both hands over the handles (8);
3. Press the "ON/OFF" switch and insert the mixing paddle
head (1) into the bucket in which you are going to carry
out the mixing;
4. To switch off the mixer, release the "ON/OFF" switch;
To operate the paddle mixer continuously:
5. Press the "ON/OFF" switch and simultaneously press the
"ON/OFF" switch lock button (6). Release the buttons and
operate the mixer with the "ON/OFF" button locked.;
6. To switch off the mixer, press the "ON/OFF" button and
release it.
The selection of the rotation speed depends on the type of
material to be mixed. The mixer has a rotary switch that
allows you to select two speed ranges and a speed control
thumbwheel that allows you to adjust the speed for each
range.
1. The rotation speed range rotary switch allows you to
select two speeds "1-2";
2. On the rotation speed control thumbwheel (10) you can
adjust the rotation speed according to the range
associated with each speed.
Position 1: 250 - 500 rpm
Position 2: 400 - 800 rpm
1. Place part of the material to be stirred in a bucket,
together with the necessary amount of water;
2. Insert the mixing paddle head into the bucket and start
the mixing process at a slow speed;
3. Continue mixing, add more material and increase the
rotation speed until the desired density is reached;
4. After finishing work always rinse the mixing paddle.
Do not overload the mixer with excessive amounts of
material to be mixed.
Publicidad
