Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not remove the pulp container (G) while the appliance is in use.
• Always unplug the appliance from the mains after use.
• Do not leave the power cord close to or in contact with sources of heat
or sharp edges.
• Do not allow long hair, scarves, ties etc. to hang over the appliance or
attachments when in use.
• Wait for all moving parts to stop before opening the appliance.
• Do not exceed the maximum quantities or operating periods indicated.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
DESCRIPTION
A Pusher
B Feeding tube
C Cover
D Sieve
E Juice collector
F Pouring spout
SAFETY SYSTEM
To start the juicer, the cover (C) must be fitted correctly
clamps properly locked
At the end of a cycle, turn the control button to "0" and wait until the
sieve (D) stops completely before removing the cover (C).
BEFORE FIRST USE
We recommend that you wash the removable parts (A, B, C, D, E, F, G)
before the first use (see section "Cleaning and care").
Unpack the appliance and then place it on a solid, stable worktop, remove
the cover (C) and take out the protective card on the sieve (D).
USING THE APPLIANCE
• Place the juice collector (E) on the body of the appliance (see
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is
properly clipped onto the drive shaft (K) (see
G Pulp container
H Locking Handles
I
J
K Drive shaft
L
(Fig.
4).
Control button
Motor unit
Anti-slip feet
(Fig.
Fig.
2).
EN
2) and the
Fig.
2).
7
Publicidad
