Saitek 3D 381 Manual Del Usuario página 2

DM32QSG.qxd 09/05/2008 09:31
4
Power on/off
Page 2
3 Audio
Phono
2
1 PS/2
5 6
BASS
3D 381 Active 2.1 Speakers
• Plug the PS/2 cable from the right satellite speaker into the "R"
output on the woofer unit and the left speaker phono cable into
1
the "L" output 2 on the woofer.
• Plug one end of the 3.5mm jackplug cable into the audio out socket
of your PC, iPod, MP3 player, PSP etc, and the other end into the
"input" socket 3 on the woofer unit.
• Power up the speaker system power by pressing the on/off switch
on the woofer unit and turn the volume control clockwise
4
switch the system on.
• With the 3D 381's volume control at 0, turn on your music source,
press Play and adjust the volume level of your PC, iPod, MP3
player, PSP etc to three quarters. Now turn up the 3D 381's volume
to the desired listening level.
• You can use the Saitek 3D 381's bass contour control
the frequency response of the speaker system to suit your listening
environment. To increase bass boost, turn the bass contour control
clockwise. To reduce bass boost, turn the bass contour control anti-
clockwise.
• Do not use your 3D 381 at excessive volume levels. If your 3D 381
sounds distorted, turn down the volume and/or bass contour
controls until the distortion stops.
WARNING:
Prolonged use at high volume may damage your hearing.
Technical Support
Can't get started - don't worry, we're here to help you!
Nearly all the products that are returned to us as faulty are not faulty
at all - they have just not been installed properly.
If you experience any difficulty with this product, please first visit our
website www.saitek.com. The technical support area will provide you
with all the information you need to get the most out of your product
and should solve any problems you might have.
If you do not have access to the internet, or if the website cannot
answer your question, please contact your local Saitek Technical
Support Team. We aim to offer quick, comprehensive and thorough
to
5
to adjust
6