Publicidad
Idiomas disponibles
Idiomas disponibles
1. DSP modes LED Indicator: These LEDs are used to indicate the DSP operation modes (NORMAL,
DJ, VOICE, LIVE, FLAT)
2. OPERATION LEDs: These LEDs indicates POWER, SIGNAL and CLIP.
3. DSP: Press this knob to change DSP modes.
4. RCA IN: This RCA plug input is used to plug a cable to get signal from CD player or other devices.
5. LINE A: This combi plug is used to plug XLR/TRS Line level signal.
6. LINE A VOL: This knob is used to increase/decrease the volume output of LINE A.
7. MIX OUT: This XLR plug provides a mixed LINE output from A and B inputs.
8. MIC/LINE switch: Press it down to use the channel as MIC input. Press it up to use the channel as LINE
input.
LINE B VOL: This knob is used to increase/decrease the volume output of MIC/LINE B.
9. MIC/
10. MIC/LINE B: This combi plug is used to plug XLR/TRS Mic/Line level signal.
11. SATELLITE OUT: This Speakon XLN plug is uset to connect output to satellites.
FUSE: The FUSE compartment contains the equipment's power protection fuse, remove it for
12.
replacement if necessary.
AC LINE INPUT: This PowerCon NAC3 plug is used to provide power supply.
13.
POWER: Switches on ( I ), off ( O ) the system.
14.
VOLTAGE SELECTOR: Switches between 110-220V main power supply.
15.
TROUBLESHOOTING
This short guide is meant to help and try to solve simple problems. If they continue and the device cannot
operate, please, don't try to repair it by yourself, return the device to your MARK PRO dealer.
If a problem occurs, carry out the following steps in sequence until find the problem solved.
1-
If the device does not operate properly, unplug the device.
2-
Check the fuse, power from the wall, all cable, etc.
3-
If all the above appears to be OK, plug the unit in again.
4-
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5-
Return the device to your MARK dealer.
4
Publicidad
