Publicidad
Idiomas disponibles
Idiomas disponibles
Filling The Rinse Aid Reservoir
Remove the rinse
1
reservoir cap by lifting up
the handle .
Close the cap after all.
3
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the
dishwasher is designed to adjust the consumption by user. Follow the
below steps.
1. Open the door, switch on the appliance.
2. Within 60 seconds after the appliance was switched on press the
program button for more than 5 seconds, and then press the Delay
button to enter the set model, the rinse aid indication blinks as 1Hz
frequency
3.
Press the Program button again to select the proper set
according to your using habits, the sets will change in the
following sequence: D1->D2->D3->D4->D5->D1. The higher the
number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or Press the Power button to end
the setting mode.
Pour the rinse aid into the
2
dispenser, being careful
not to overfill.
42
V.1
Publicidad
