Publicidad
Idiomas disponibles
Idiomas disponibles
•
When the buzz is on, touch any button to stop it. The compressor,fan shut down and all the functions freeze until the
tank is emptied and back in right position.
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
EMPTYING THE WATER TANK
The water tank built in unit, will fill up and shut the unit down once it is full. It will run again once you empty the water tank
and installed properly.
•
When the tank is full, the unit will make a buzzing sound, and the "Water
•
Touch the POWER button to turn off the unit.
•
Pull on the water tank and simply slide out of the body of the dehumidifier.
•
Empty the water into an area with a drain or outside.
•
Clean the inside of the tank as well as the outside.
•
Replace the empty tank back into the unit.
•
Press the POWER button to resume operating.
•
If the Water Full light does not extinguish, check that the float is correctly in place.
CONTINUOUS DRAINING
For continuous operation or unattended dehumidification, please connect the attached drain hose to the unit. Condensate
water can be automatically flow into a bucket or drain by gravity.
•
Set the unit in a horizontal surface and stable position.
•
Switch off the unit before operating.
•
Securely and properly connect the drain hose and make sure it is not kinked and clear of obstruction.
•
Place the outlet of hose over a drain or bucket and ensure that water could freely flow out of the unit.
•
Do not submerge the end of hose into water; otherwise, it can cause "Air Lock" in the hose.
14
EN:
DEHUMIDIFIER
| Instruction Manual
Full" light will turn on.
drain-pipe
Publicidad
