Publicidad
Idiomas disponibles
Idiomas disponibles
31.
Working notes
Perform the following checks regularly before commissioning and during operation:
•
Always hold the device with both hands on the front and rear handle.
•
Is the device complete and correctly installed?
•
Make sure that all nuts and bolts are tightened.
•
Is the device in good and safe condition?
•
Are all safety functions in order?
•
Is the gas tank full?
•
Are the engine and muffler free of deposits, leaves or lubricants?
•
Is the handle clean and dry (no oil, grease or resin)?
•
Is the workplace free of obstacles that you could trip over?
•
Are you wearing the necessary protective device?
•
Have you read and understood the instructions?
•
Are the throttle levers smooth and the locking knob functional?
•
Is the ON/OFF switch functional?
•
Make sure that the gear device has sufficient lubrication (see "Maintenance").
32.
Maintenance and care
Before any maintenance and cleaning work
•
Switch off the engine
•
Wait until the engine has come to a standstill
•
Disconnect spark plug connector (except when adjusting the idle speed)
Due to the risk of fire, do not carry out maintenance work in the vicinity of open flame.
Maintenance and cleaning work not described in this chapter may only be carried out by
customer service.
Safety devices that have been removed for maintenance and cleaning must be properly checked
and reattached before use.
Only use original parts. Other parts may cause unforeseeable damage or pose a danger to the
user.
Maintenance
Wear gloves to avoid injury.
To ensure a long and reliable use of the device, carry out the following maintenance
work regularly.
Check the device for obvious defects such as
•
loose fastenings
•
worn or damaged components
Original user manual FX-LB126ECO_de_en_fr_ita_es_rev01
38
Publicidad
