SolaX Power DataHub1000 Manual De Instalación página 65

Pre-power Check / Prüfung vor dem Einschalten / Vérification avant mise sous tension
/ Comprobación previa al encendido / Verificação Antes da Ligação à Corrente /
Pre-powercheck / Verifica prima dell'accensione / Wstępne sprawdzenie zasilania /
Kontrola před zapnutím / Kontroll före start / Verificare pre-alimentare / Проверка
преди включване / Kontrol før idriftsættelse / Προκαταρκτικός έλεγχος ισχύος /
Eeltoitekontroll / Käynnistystä edeltävä tarkistus / Provjera prednapajanja / Áram alá
helyezés előtti ellenőrzés / Patikrinimas prieš įjungimą / Pirmspalaišanas pārbaude
/ Kontrola pred spustením / Preverjanje napajanja / Çalıştırma Öncesi Kontrol /
Verificação pré-alimentação
NO. Inspection standards
1 Check whether DataHub has been installed firmly.
2 Check whether the cable is reliably connected.
Check whether the cables meet the requirements of strong and weak current
3
cabling plan.
Check whether the cables are bundled neatly, and the orientation are the
4
same.
Check whether there are excess copper wires and cable ties left on the
5
cables.
Definition of Indicators / Definition der Anzeigen / Signification des voyants /
Definición de indicadores / Definição dos Indicadores / Definitie van indicators /
Definizione degli indicatori / Definicje wskaźników / Definice indikátorů / Definition
av indikatorer / Definiția indicatorilor / Дефиниция на показателите / Definition på
indikatorer / Ορισμός ενδεικτικών λυχνιών / Märgutulede selgitus / Merkkivalojen
määritelmät / Značenje pokazatelja / A jelzések meghatározása / Indikatorių aprašymas
/ Indikatoru definīcija / Definícia kontroliek / Opredelitev kazalnikov / Göstergelerin
Tanımı / Definição de Indicadores
*Note: Use a power adapter to connect DataHub to a 100~220V power outlet.
Observe the LED indicator to see if DataHub is operating normally.
After power on, please wait for 30 seconds prior to indicator check.
Indicator
Run (Green)
Always on or off
Serve (Green)
Alarm (Red)
Status
Flash
On
Off
Off
On
Description
The program runs normally
The program runs abnormally
The network connection is normal
The network connection isn't normal
No alarm
Device alarms
61