Publicidad
Idiomas disponibles
Idiomas disponibles
GEAR CASE
o To keep your drive system working
properly, the gear case and area around
the drive should be kept clean and free
of trash build-up.
Clean under the drive
cover twice a season.
o The gear case is filled with lubricant to
the proper level at the factory.
The only
time the lubricant needs attention is if
service has been performed on the gear
case.
.
Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
ENGINE
Maintenance,
repair, or replacement
of
the emission control devices and systems,
which are being done at the customers
ex-
pense, may be performed by any non-road
engine repair establishment
or individual.
4.
Warranty repairs must be performed by an
authorized
engine manufacturer's
service
5.
outlet.
6.
LUBRICATION
Use only high quality detergent oil rated
with API service classification
SG-SL.
Select the oil's SAE viscosity grade
according
to your expected operating
temperature.
SAE VISCOSITY
GRADES
4O
°F
-20
0
30
32
40
60
80
100
°c -_o
-2;
-_;
;
1;
_o
_o
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
NOTE:
Multi-viscosity
oils (5W30, 10W30
etc.) improve starting in cold weather, and
you should check your engine oil level fre-
quently to avoid possible engine damage
from running low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE:
Before tipping lawn mower to
drain oil, empty fuel tank by running en-
gine until fuel tank is empty.
1. Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2.
Remove oil fill cap/dipstick;
lay aside
on a clean surface.
Wipe off any spilled oil from lawn
mower or side of engine.
Fill engine with oil. Slowly pour oil
down the oil fill spout into the engine.
Wait one minute to allow oil to settle.
Use guage on oil fill cap/dipstick
for
checking level.
Insert dipstick into
the tube and rest the oil fill cap on the
tube.
DO NOT thread the cap into the
tube when taking reading.
Oil fill cap /
dipstick
Upper _
mark
7. Continue adding small amounts of
oil and rechecking
the dipstick until it
reads full. DO NOT overfill, or engine
will smoke on startup.
8. Always be sure to retighten oil fill cap/
dipstick before starting engine.
9. Reconnect spark plug wire to spark
plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter every 100 hours of
operation or every season, whichever oc-
curs first. Service air cleaner more often
under dusty conditions.
14
Publicidad
