Worx WX652.X Manual De Instrucciones página 11

purchased from good DIY shops. Available
grades are Coarse, Medium and Fine.
— Use coarse grits to sand down rough finishes,
medium grit to smooth the work and fine grit
to finish off.
— The higher the grade number, the finer the
grit. For rough work start with a low grade of
grit. (e.g. 60 grit) and change to a higher, finer
grade (e.g. 120 grit) for finishing. If you use a
fine grade for rough surfaces it will soon clog
and need changing.
— It is best to make a trial run on a scrap piece
of material to determine the optimum grades
of sandpaper for a particular job.
8. SANDING PLATE BRAKE
An integrated sanding plate brake reduces the
speed when running at no load so that scoring is
avoided when placing the machine on the work
piece. A continuously increasing no-load speed
over the course of time indicates that the sanding
plate brake is worn and must be replaced by an
authorized customer service location.
WORKING HINTS FOR YOUR
SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speeds. Always use sand paper that is
suitable for the material you want to sand.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn it off
only after you stop sanding. For the best results,
sand wood in the direction of the grain.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sand paper to wear away it will
damage the base-plate. The guarantee does not
cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for
the final surfaces. If necessary, first make a test
run on scrap material.
Random orbital sander
Use only good quality sand paper.
The sand paper controls the sanding efficiency,
not the amount of force you apply to the tool.
Excessive force will reduce the sanding efficiency
and cause motor overload. Replacing the sand
paper regularly will maintain optimum sanding
efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.
11
EN