Publicidad
~CAUTION:
SAFETY
Before installation, disconnect the battery
negative (-) terminal to prevent damage
to the unit, fire and/or possible injury.
PRACTICE SAFE SOUND™
Continuous exposure to sound pressure levels over IOOdB may
cause permanent hearing loss. High powered auto sound systems
may produce sound pressure levels well over 130dB. Use common
sense and practice safe sound.
(I) Punch Pro Tweeter
Mounting hardware
CARTON CONTENTS
INSTALLATION CONSIDERATIONS
Before beginning
any installation,
follow these
simple
rules:
I.
Be sure to carefully read and understand the instructions before attempting to
install these speakers.
2.
For safety, disconnect the negative lead from the battery prior to beginning the
installation.
3.
For easier assembly, we suggest you run
all
wires
prior
to
mounting
your
speakers
in
place.
4.
Use high quality connectors for a reliable installation and to minimize
signal
or
power loss.
5.
Think before you drill! Be
careful not to cut or drill into gas tanks, fuel lines,
brake or hydraulic
lines, vacuum
lines or
electrical
wiring when working on
any
vehicle. If installation in a boat, take care not to cut or drill through the main hull.
6.
Never
run
wires underneath
the
vehicle. Running the wires inside
the
vehicle or
hull
area
provides the best
protection.
7.
Avoid running wires over or through sharp edges. Use rubber or plastic
grommets
to protect any wires routed through metal, especially the firewall.
MOUNTING
I.
Determine where the
speakers
will be
mounted.
Ensure an
area
large enough for
the speaker to mount
evenly.
Be sure that the mounting location is deep
enough
for the
speaker
to fit; if
mounting
in
a
door,
operate all functions (windows, locks,
etc.) through their entire
operating
range to ensure there is no obstruction.
2.
Refer to the specification chart
to
determine the proper diameter
hole
to cut
for your
speaker
model.
The template provided also gives the proper cutout
size.
3.
Mark the locations for the mounting screws. Drill the holes with a 1/8" bit.
4.
Feed the speaker wires through the cutout and connect to the speaker terminals.
Be sure to observe proper polarity when connecting the
wires.
The speaker's
positive terminal is indicated with
a
red
ring.
5.
Tighten the screws until the speaker
is
snug
in
place to prevent rattling. Do not
over tighten
the
screws.
2
:j~
',,/~/
,
,
/ _ _
Align Holes
__ ,
I
..... _ _ _ _ _ _
Example of standard door installation
Publicidad
