Efco Power MTT 3600 Manual De Instrucciones página 20

inspect the gasket.
5. Immediately replace fuel cap and hand
en
tighten. Wipe up any fuel spillage.
GB
NOTE: It is normal for smoke to be emitted
from a new engine during and after first use.
F
WARNING: Check for fuel leaks, if any
are found, correct before use. Contact a
D
Servicing Dealer if necessary.
E
Chain Oil System
The bar and chain require continuous lubrication.
NL
Lubrication is provided by the automatic oiler
system when the oil tank is kept filled. Lack of oil
P
will quickly ruin the bar and chain. Too little oil
will cause overheating shown by smoke coming
GR
from the chain and/or discoloration of the bar. In
freezing weather oil will thicken, making it
TR
necessary to thin bar and chain oil with a small
amount (5 to 10%) of Diesel Fuel or kerosene. Bar
CZ
and chain oil must be free flowing for the oil
system to pump enough oil for adequate
lubrication.
SK
CAUTION: Never use waste oil. Always use
RUS
biodegradable lubrificant that is specific
for bar and chain and that is better for the
UK
environment and chainsaw's parts.
PL
CAUTION: Do not use dirty, used or
otherwise contaminated oils. Damage
H
may occur to the oil pump, bar, or chain.
WARNING: Do not use waste oil! Medical
LV
studies have shown that renewed contact
with waste oil can cause skin cancer.
EST
1. Fill the oil tank every time engine is fueled.
LT
Chain saw should use approximately one tank
of oil per tank of fuel.
RO
2. The automatic oil pump is a positive
displacement pump operated through gears
driven off the clutch drum assembly.
The pump will not oil at idle speeds.
16
Preparation for Cutting
Proper Grip on Handles.
Refer to Safety Section for appropriate Safety
Equipment.
1. Wear non-slip gloves for maximum grip and
protection.
WARNING: Hold the saw firmly with both
hands. Always keep your LEFT HAND on
the front handlebar and your RIGHT HAND on
the rear (throttle) handle, so that your body is
to the left of the chain line. Never use a cross-
handed grip, or any stance which would place
your body or arm across the chain line. Left-
handers should follow these instructions too.
2. Maintain a proper grip on the saw whenever
the engine is running. The fingers should
encircle the handlebar and the thumb is
wrapped under the handlebar. This grip is
least likely to be broken (by a kickback or
other sudden reaction of the saw). Any grip in
which the thumb and fingers are on the same
side of the handle, is dangerous because a
slight kick of the saw can cause loss of control.
WARNING:
Proper Cutting Stance
Weight should be balanced on both
-
feet - feet on solid ground.
Keep arm with elbow locked in a
-
"straight arm" position to withstand
any kickback force.
Your body should always be to the left
-
of the chain line.
Thumb on underside of handlebar.
-
Basic Cutting Procedure
Practice cutting a few small logs using the
following technique to get the "feel" of using
your saw before you begin a major sawing
operation.
1. Take the proper stance in front of the wood
with the saw idling.
2. Accelerate the engine to full throttle just
before entering the cut by squeezing the
throttle trigger.
3. Begin cutting with the saw against the log.