Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1.
Unfold metal wires attached to the top of both ropes.
2.
Insert 4 fresh AA alkaline batteries (recommended)
into the battery compartment located on the
control box.
3. Place FOAM PAD up against mounting object.
Wrap HOOK AND LOOP FASTENER over the top of the
MOUNTING OBJECT. (green arrows)
Pull the hook and loop through the METAL LOOP in
front of the CONTROL BOX, back over the MOUNTING
OBJECT, (red arrows) and attach to the HOOK AND
LOOP FASTENER strip on the back side of the
CONTROL BOX located below the battery cover.
IMPORTANT: Pull HOOK AND LOOP FASTENER tight so
the control box is very tightly secured to the mounting
object or swinging motion will not function.
1
2
3
HOOK
AND
LOOP
FASTENER
Page 3
STRAIGHTEN
WIRES
FOAM PAD
STRAIGHT
WIRE POSITION
MOUNTING
OBJECT
THROUGH
METAL
LOOP
Publicidad
