Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
GENERAL INFORMATION
The assembled group of the appliance is
secured by 4 fi xing screws (which protect it
during handling and transport operations),
fi gure 1.
FIXING SCREWS REMOVAL
Before using the appliance, it is necessary
to remove the fi xing screws by turning
counter clockwise.
N.B. If the fi xing screws are not removed,
this will cause strong vibrations and irregular
movements during the washing cycle with
subsequent damages.
Once unscrewed, pull them out with spacer
bushes as shown in fi gure 2.
Figure 2
1
12 mm
10
Figure 1
2
Seal the holes with the appropriate caps
provided as shown in fi gure 3.
Figure 3
x 4
POSITIONING OF APPLIANCE
In order to avoid damages or malfunctions, the
appliance must not be installed on roofs, bal-
conies, under canopies or in places where it
may be exposed to atmospheric agents.
Make sure the electrical cable and hoses (wa-
ter inlet and drain hoses) on the rear of the
appliance are not pressed.
To ensure the stability of the appliance, avoid-
ing strong vibrations during washing and
spinning cycles, it is necessary to put the ap-
pliance on a levelled, smooth, dry, solid sur-
face not raised from the fl oor level. In order
to balance any difference in levels of the fl oor,
it is possible to intervene on the feet modify-
ing the height by screwing and unscrewing in
accordance with the necessities as shown in
fi gure 4.
Figure 4
Cabinet
MOBILE
PIEDINO
Foot
Publicidad
