YATO YT-81775 Manual De Instrucciones página 8

PRODUCT CHARACTERISTICS
Garden refl ector, after having installed the light source, is designed to illuminate places outdoors. Thanks to its sealing
it may be used outdoors to limited extent of use. The pin facilitates installation, which does not require any additional to-
ols. Both traditional bulbs and LED lamps may be used as the light source. Possibility of using LED lamps is associated
with low power consumption and low power loss resulting from refl ector heating up. Correct, reliable and safe operation
of the product depends on proper operation, therefore:
Before starting product operation, please read this manual and keep it.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recom-
mendations specifi ed in this manual.
PRODUCT ACCESSORIES
The product is supplied with a pin and mounting screw. The light source is not supplied with the product.
TECHNICAL DATA
Parameter
Catalogue number
Rated voltage
Rated frequency
Electrical insulation class
Protection class
Max. power of light source
Type of mounting of light source
Type of connecting cable
Weight
INSTALLATION OF LUMINAIRE
It is required that the luminaire is installed by qualifi ed electrician.
Prior to starting the installation of luminaire, installation or replacement of light emitting element, it is necessary to turn
off the power supply to network to which the luminaire is to be connected! Failure to observe this recommendation may
pose a threat of electric shock, which can result in serious injury and even death.
The source of power supply must have two power cords and third protective cord. The power supply network must also
have residual-current fuse with tripping current of no more than 30 mA.
In case of damage or breakage of the protective glass, replace it immediately!
The luminaire may not be used without or with broken protective glass!
It is not allowed under no circumstances to direct the light beam to surfaces less than 1 m from the protective glass or
surfaces made of fl ammable materials, as this may cause fi re!
Assembly of product (II)
Prior to use, affi x the pin to a grip handle of lamp's cover. To do this, loosen the screws affi xing the grip handle to the
cover, but do not unscrew them completely. Slide the grip handle out of the cover. Screw in the pin using the grip han-
dle. The grip handle with a pin slide into the cover and tighten both screws affi xing the grip handle to the cover. These
screws to be tighten with suffi cient force so that the cover remains in set position, and it is possible at the same time to
change the position without loosening the screws.
8
O R I G I N A L
GB
Measuring unit
[V~]
[Hz]
[W]
[kg]
I N S T R U C T I O N S
Value
YT-81755
220-240
50
I
IP54
35
GU10
3 x 1 mm
2
0.38