Safety; Danger Caused By Electric Current; Safety Instructions For The Electrical Connections - Graef CH 501 Manual De Instrucciones

Safety

Danger caused by electric current

Mortal danger is caused by contact with energised cables or components!
Please observe the following safety instructions in order to prevent an expo-
sure to electric current:
- Do not use the unit if the mains cable or plug are damaged.
- In this case, you should let the Graef Customer Service install a new con-
nection cable before using the appliance again. This may be done also by
an authorised specialist.
- Do not open the housing under any circumstances. If live connections are
touched or the electrical and mechanical construction are modified, there
is the danger of electric shock.
- Never touch live parts. This can cause an electric shock and may cause
even death.

Safety instructions for the electrical connections

For safe and fault-free operation of the unit, the following requirements
have to be met during the electrical connection:
- Before connecting the unit, compare the connecting data (voltage and
frequency) on the type plate with those of your energy network.
- These details must correspond so that no damage occurs to the unit. In
case of doubt ask your trained electrician.
- The socket has to be protected at least by a 10 amps circuit breaker.
- Make sure that the power cable is not damaged and is not laid across hot
surfaces or sharp edges.
- The connecting cable must not be stretched tightly.
- The electric safety of the unit is ensured only when it is connected to a
socket with protective conductor installed correctly. Operation on a socket
without protective conductor is forbidden. If in doubt, let the house instal-
lation checked by a trained electrician. The manufacturer shall not assume
responsibility for damage which has been caused by absent or interrupted
protective conductor.
18