Publicidad
Idiomas disponibles
Idiomas disponibles
• install c artridge, thenreplace covermaking
surethetabsarealigned withtheslotsin the
backplate.Fastenscrewsecurely.
Lip
--f ,_
Back
IIi lIL til
c°ver
_
" Cover
Cadddge
MUFFLER
I
Inspect and replace corroded muffler as it
could create a
fire hazard and/or damage•
SPARK
PLUG
Change your spark plug each year to
make your engine start easier and run
better, Set spark plug gap at .030 inch.
CLEANING
IMPORTANT:
For best performance,
keep mower
housing
free of built--up
grass and trash.
Clean underside
of
mower
housing
after each use.
CAUTION;
Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with the spark
plug.
o Turn lawn mower on its side_ Make sure
air filter and carburetor are upo Clean the
underside of your lawn mower by
scraping to remove build--up
of grass
and trash.
o Clean engine often to keep trash from
accumulatingo A clogged engine runs
hotter and shortens engine life.
o Keep finished surfaces and wheels free
of all gasoline, oil, etc
o We DO NOT recommend using a
garden hose to clean lawn mower
unless the electrical system, muffler, air
filter and carburetor are covered to keep
water out. Water in engine can result in
shortened enc ine life.
CAUTION:
Before
performing
any
service
or adjustments:
•
Release control
bar.
-
Make sure the blade and all moving
parts have completely
stopped.
o
Disconnect
spark plug wire from
spark plug and place where it cannot
come in contact
with plug,
LAWN
MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST
CUTTING
HEIGHT"
in
the Operation
section
of this manual.
REAR DEFLECTOR
The rear deflector,
attached
between
the
rear wheels
of your lawn mower,
is
provided
to minimize
the possibility
that
objects
will be thrown
out the rear of the
lawn mower into the operator's
mowing
position,
tf the rear deflector
becomes
damaged,
it
should
be replaced.
TO ADJUST
HANDLE
Your lawn mower
handle
can be raised
or
lowered
for your mowing
comfort.
Four
(4) positions
are available:
high, medium
high, medium
low and low.
Handles
are
shipped
mounted
in the medium
low
position.
o To change
from medium
low to medium
high position,
the upper and lower
handle sections
wilt have to be turned
over o
o Remove
the cable clips.
o Remove
the controls
and operator
presence
control
bar from the upper
handle.
.
Remove
hairpin cotters.
o Disconnect
the lower handle
from the
handle brackets.
o Turn the handle over and reassemble
the hairpin cotters that have been
removed,,
o Reassemble
the controls
and the
operator
presence
control
bar to the
upper handle.
CAUTION:
The operator
presence
control
bar must pivot freely to permit blade brake
engagement
when control
bar is released.
Do not over tighten
the fasteners
holding
the controls
to the upper handle.
. To change
from medium
tow to high
position
only the upper handle
section
wilt have to be turned
over,
t3
Publicidad
