Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION NOTES
It is important that you leave your device upright for at least 4 hours before
switching it on to allow the cooling system to adjust.
•
When you move the unit, do not tilt it more than 45 degrees. Do not apply
force to parts such as the condenser, door or handle. They can distort and
interfere with the operation of the cooler. Make sure ALL packaging is
removed before installation.
•
Make sure there is enough space around the product to allow air to circulate
freely.
•
Do not place the product near heat sources, in direct sunlight or in humid
rooms.
•
Make sure that the supply voltage of the power outlet corresponds to the
voltage indicated on the type plate.
•
Insert the plug firmly into the socket.
•
The socket outlet must be earthed. Do not plug the plug into unearthed
sockets and do not use an extension cable.
•
The product is equipped with adjustable feet. Once the product is in place,
adjust them so that the refrigerator is level and does not slip.
Note: Do not place the product in places where the ambient temperature can
fall below 5 °C, e.g. in the garage or shed.
Space requirements
•
Position the unit so that there is sufficient
space to open the door.
•
Make sure that the air can circulate freely at
the back of the housing, which is necessary for
cooling the compressor and condenser. Leave
at least 100 mm clearance at the back of the
unit and 50 mm clearance at the sides.
EN
21
Publicidad
