Beamz 150.460 Manual De Instrucciones página 6

AUTO PROGRAMS
Show Mode: This mode allows either a single unit or several units linked
together, to run one of seven shows that you choose.
1. Press the up or Down button until one of seven programs is
displayed, and press ENTER. The picture below details a proper
MENU structure conversion.
2. You have chosen one of seven programs and you press
ENTER, you can the SPEED, DIM, STROBE change.
SOUND MODE
Press the "up" or "down" button to select "Sound".
MAIN FUCTIONS
Display Inversion
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "RDIS" is displayed, press
"ENTER" Either "OFF" or "ON" will be displayed.
OFF:
Display normal mode is for floor standing the unit.
ON:
Display inversion mode is for hanging the unit upside down.
Pan Inversion
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "MSET" is displayed,
press "ENTER" Either "BLTO" or "NCAL" will be displayed. Select "NCAL" press "ENTER" use the "UP" or "Down" button until
"PAN" is displayed, Press "ENTER" select "REV" press "ENTER" you can select "NO"(Normal) or "Yes"(Pan inversion).
Tilt Inversion
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "MSET" is displayed,
press "ENTER" Either "BLTO" or "NCAL" will be displayed. Select "NCAL" press "ENTER" use the "UP" or "Down" button until
"TILT" is displayed, Press "ENTER" select "REV" press "ENTER" you can select "NO"(Normal) or "Yes"(Tilt inversion).
Led display after 20 sec off
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "CLDI" is displayed, press
"ENTER" Either "ON"(After 20 sec led display off) or "OFF"(Led display on) will be displayed.
Reset
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "RST" is displayed, press
"ENTER" Either "OFF" or "ON" will be displayed.
Sound MODE
Press the MODE button you see on display "SET" press "ENTER" use the "UP" or "Down" button until "MIC" is displayed, press
"ENTER" and select the sound sensitivity between value 0 and 100. Press the "ENTER" button for confirmation after value
selection.
6
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN