DynaTrap DT1200 Manual Del Propietário

ASSEMBLY GUIDE
MODEL: DT1200/DT12S0
ASSEMBLY INSTRUCTIONS
I. Unpack the unit, and place ii on the ground. Pull the cord light through the pole stand as in Figure l.
2. Insert upper and lower tubes and press the spring bulge to ensure both tubes ore securely placed, as in Figure 2.
3. Insert the connector piece into the stand base. Align pole and connect by screwing nut as in Figure 3.
4. Your Dynatrap is now ready to be connected to the electrical outlet.
5. Turn switch on.
INSTRUCCIONES PARA INSTALACION
I. Desempaque la unidod,
y
col6quela en el piso. Joie firmemente el cable atraves del tubo de lo base, como se muestra en
lo Figura l.
2. lnserte el tubo superior e inferior y opriete el bot6n con resorte para osegurorse que ombos tubos son colocodos seguro-
mente, como se muestra en lo Figura 2.
3. lnserte el conector de plastico en lo porte inferior de lo base. Alinee el tubo y conecte por medio de lo tuerco de plastico,
como se muestro en lo Figura 3.
4. Su Dynatrap esta lista para ser conectoda a la fuente de corriente.
5. Enciendo el switch.
Figure l
Pull the cord through the pole stand
.....................
upper tube
Figure 2
Insert both upper ond lower tubes together ond
make sure the spring bulge is securely ploced.
press the spring bulge
---
•
Figure 3
Insert bottom connector piece into stond base.
Align pole ond connect by screwing nut.
/
On/ Off switch
locoted under the
roin cover
I
Figure 4
0
0
Place the unit in
upright position
Ground
•