Publicidad
Idiomas disponibles
Idiomas disponibles
CUSTOMER
a
.................
RESPO
mLmTUE$
ENGINE
LUBRICATION
Use only high quality detergent oil rated with API service
classification SF orSG Select theoil'sSAE viscositygrade
according to your expected operating temperature,
SAE VISCOSITY
GRADES
t
_F
-20"
0 °
30°
32? 40'
60•
_0 _
_00"
°c -_o"
............
:aO"
..............
-1o,
.... o'
_o o
20,
_o, 40,
TEMPERATURE
RANGE
ANT1CIPATEO
BEFORE
NEXTOIL
CHANGE
NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
32°F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil,
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year ifthe lawn
mower is not used for 25 hours in one year,.
Check the crankcase oil level before starling the engine
and after each five (5) hours of continuous use.,Tighten oil
plug securely each time you check the oil level,
TO CHANGE ENGINE OIL (See Fig. 10)
NOTE: Before tipping lawn mower to drain oil, drain fuel
tank by running engine until fuel tank is empty_
.
Disconnect spark pfug wire from spark plug and place
wire where it cannot come in contact with spark plug,
•
Remove engine oil cap; lay aside on a clean surface,
•
Tip lawn mower on its side and drain oil into a suitable
container° Rock tawn mower back and forthto remove
any oil trapped inside of engine
•
Wipe off any spilled oii on tawn mower and on side of
engine.,
,
Fill engine with oil.
Fi!l onty to the "FULL" line on the
dipstick,. DO NOT OVER FILL.,
•
Replace engine oit cap.
•
Reconnect spark plug wire to spark plug,,
AIR FILTER
Your engine will not run properly and may be damaged by
using a dirty air filter.
Replace the air filter every year, more often if you mow in
very dusty, dirty conditions_ Do not wash air filter.,
TO CHANGE AIR FILTER (See Fig,,1t)
°
Remove the air filtercover by turning counterclockwise
to the stop and pull away from collar,,
°
Remove filter from inside of cover,
°
Clean the inside of the cover and the collar to remove
any dirt accumulation,
°
Insert new filter into cover_,
°
Put air filter cover and filter into collar aligning the tab
with the slot,
°
Push in on cover and turn clockwise to tighten.,
CONTAINER
FIG. 10
COLLAR
SLOT
COUNTER-
CLOCKWISE
TO REMOVE
AIR FILTER COVER
4CLOCKWISE
TO TIGHTEN
FIG. 11
MUFFLER
inspect and replace corroded muffler as it could create a
fire hazard and!or damage,,
SPARK
PLUG
Change your spark plug each year to make your engine
start easier and run better. Set spark plug gap at ,030 inch,
CLEANING
IMPORTANT:
FOR
BEST
PERFORMANCE,
KEEP
MOWER
HOUSING
FREE
OF BUILT-UP
GRASS
AND
TRASH,
CLEAN
UNDERSIDE
OF MOWER
HOUSING
AFTER EACH USE,
'13
Turn lawn mower on its side., Make sure air filter and
carburetor are up., Clean the underside of your Iawn
mower by scraping to remove build-up of grass and
trash°
•
Clean engine often to keep trash from accumulating. A
ctogged engine runs hotter and shortens engine life_,
°
Keep finished surfaces and wheels free of all gasoline,
oil, etc
-
We DO NOT recommend using a garden hose to clean
lawn mower unless the electrical system, muffler, air
filter and carburetor are covered to keep water out,
Water in engine can result in shortened engine life
Publicidad
