Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
CAUTION: If the manual circuit breaker trips, there is a risk of fire. Reset the unit by pressing the reset
button located on the bottom of the power pack after checking the following:
• Cable is correctly inserted in the cable terminals at the bottom of the power pack and no
wire insulation is under the terminal clamping plate.
• Check for overload or short circuits (wires touching) along the cable.
• Check that fixtures are correctly installed on the cable and that there are no short circuits.
Make all repairs before pressing reset button and operating the lighting system.
If you want to test the photo eye during the day, plug the power pack and cover the photo eye so the
photo eye does not receive any light. Press the setting button to "A", making sure the photo eye is
completely covered, and your light fixtures will turn on. Uncover the photo eye and your lighting
fixtures will shut off automatically.
Note: There will be a 30-60 second delay between the lights turning on/off once the photo eye is
covered/uncovered.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Fixture doesn't work
1. The power pack is not plugged
in and turned on.
2. Low-voltage cables are not
connected to the power pack
properly.
3. Fixture connector is not properly
installed on the low-voltage
cable.
4. The power pack is overloaded.
5. The manual circuit breaker has
tripped.
7
1. Plug the power pack into the
outlet and turn the power pack on.
2. Ensure the wires are inserted
properly into the cable terminals
and the term ina I screws are
securely tightened.
3. Make sure the connect pins
pierce wire insulation and make
proper contact with the wire.
4. Check the total wattage of all
connected fixtures. Total wattage
must not exceed 200 watts.
5. Push the reset button on the
bottom of the power pack to reset
the circuit breaker.
Lowes.com/portfolio
Publicidad
