Descargar Imprimir esta página

Akai AM-U61 Manual Del Usuario página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

OPERATIONS
RECORDING
DEPRESS
THE
POWER
SWITCH
TO ean ON
THE
POWER.
@ RECORDING
FROM SOURCE
MONITORING
1. Set the REC SELECTOR
to the desired recording source:
®@ To monitor
the source signals, turn on the Input switch
PHONO:
Recording from a record.
corresponding to the position of the REC SELECTOR.
For
TUNER:
Recording a radio broadcast.
example,
if recording from a record, turn on the PHONO
AUX:
Recording from an equipment connected
to the
switch.
AUX jacks.
@
During
recording,
to
monitor
an
equipment
beside the
2. Put the tape deck(s) into recording standby mode.
source equipment, turn on the Input switch corresponding
3. Play back the source equipment and adjust the tape deck(s)'s
to the desired equipment.
For example, you can monitor
recording level.
a radio broadcast while
recording
from a record just by
4. Set the source equipment ready to play back from the be-
turning on the TUNER switch.
ginning.
®
Comparison of the source signals to the just recorded signals
5. Play back the source equipment and put the tape deck(s)
Possible only with a 3-head tape deck(s).
into recording mode.
1. Set the Tape Monitar switch of the tape deck(s) to the Tape
*
The VOLUME,
BALANCE,
BASS
and TREBLE
controls
position.
can be adjusted and the SUBSONIC and LINE STRAIGHT
2. Turn on the TAPE-1 or - +2 switch to monitor the just record-
switches and MUTING
and LOUDNESS
buttons can be set
ed signals.
during recording but they will have no effect on the record-
3. Turn
on the Input switch corresponding
to the source
ing signals,
equipment to monitor the source signal.
LEFT
TAPE 2 REC
LEFT LINE IN
Source
RIGHT TAPE 2 REC
RIGHT
LINE IN
LEFT
TAPE 1 LEFT
REC
LINE IN
RIGHT
RIGHT
TAPE 1 LINE IN
REC
TAPE 1 and/or TAPE 2
@ TAPE DUBBING
From TAPE-1 to TAPE-2
1. Set the REC SELECTOR
to DUBBING
1 > 2.
6. Play back the playback tape deck and put the recording
2. Put the tape deck connected to the TAPE-2 jacks to record-
tape deck into recording mode.
ing standby mode.
*
If using a 3-head
tape deck
for recording,
turn on the
3. Put the tape deck connected to the TAPE-1
jacks to play-
TAPE-2 switch to monitor the just recorded signals and turn
back mode.
on the TAPE-1 switch to monitor the source signals.
4. Adjust the recording tape deck's recording input levels.
*
Dubbing can also be done from a tape deck connected to the
5. Set the playback tape deck ready to play back from the
TAPE 2 jacks to a tape deck connected the TAPE
1 jacks.
beginning.
in this case, set the REC SELECTOR
to DUBBING 2 > 1.
LEFT
TAPE 2
LEFT
REC
LINE IN
CEE
LEFT
LINE
TAPE 1
OUT
PLAY
RIGHT
RIGHT
3
LINE
TAPE 1 AM-U61
TAPE 2
LINE IN
OUT
PLAY
REC

Publicidad

loading