Descargar Imprimir esta página

Crafstman WEEDWACKER 358.795123 Manual De Instrucciones página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

area. T he right a nd wrong ways are
shown b elow,
Tip ofthe Line I Line Crowded
Into
Does T he Cutting Work A rea
• The line willeasily remove grass
and weeds f rom around w alls,
fences, trees andflower b eds, butit
also cancutthetender b ark oftrees
orshrubs a ndscar f ences. Tohelp
avoid damage especially todelicate
vegetation ortrees withtender b ark,
shorten l ine to4-5in.(10-13 cm)
and useatlessthan fullthrottle.
• For t rimming orscalping, use less
than fullthrottle t oincrease linelife
and decrease head wear, e specially:
• During l ight d uty cutting.
• Near o bjects a round w hich theline
canwrap such assmall p osts,
trees orfence wire.
• Formowing orsweeping, usefull
throttle f ora good clean job.
TRIMMING - Hold thebottom ofthe
trimmer head about 3 in.(8cm) a bove
theground a ndatanangle. Allow only
thetipoftheline tomake contact. Do
not f orce trimmer lineinto work area.
Trmm ng
/,i'
-
3 in. (8 cm)
A'"_',,_\
Above
Ground
_
"_ _._t
SCALPING
- The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 in. (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
.......
,
MOWING - Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
I1
'!L'
h_
SWEEPING
- The fanning action of
the rotating line can be used for a
quick and easy clean up. Keep the
line parallel to and above the surfaces
being swept and move the tool from
side to side.
Sweeping
MAINTENANCE
SCHEDULE
WARNING:
Disconnect the spark plug before performing maintenance
except for carburetor
adjustments.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Inspect muffler and spark arresting screen
Replace spark plug
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Every 50 hours of operation
Yearly
8

Publicidad

loading