Descargar Imprimir esta página

MTD 510 Serie Manual Del Operador página 14

Ocultar thumbs Ver también para 510 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance& Adjustments
WARNING!
Do not make any adjustments
without
2.
first stopping
the engine,
disconnecting
the spark
plug wire and grounding
it against
the engine.
(_
Always wear safety glasses during
operation
or
while performing
any adjustments
or repairs.
Maintenance
Engine
Refer to the Engine Operator's
Manual packed with your log
splitter
for all engine
maintenance.
Tire Pressu re
The max recommended
operating
pressure is 30 psi. Do
not, under any circumstances,
exceed the manufacturer's
recommended
psi. Maintain
equal pressure on all tires.
WARNING!
Excessive pressure when seating beads
may cause the tire/rim assembly to burst with force
sufficient to cause serious injury. Refer to the
sidewall of the tire for the recommended pressure.
HoseClamps
Check the hose clamps on the suction
hose (attached
to
the side of the pump) to ensure they are tight
before each
use. Check the hose clamps on the return hose at least
once a season.
Hydraulic Filter
Change the hydraulic
filter every 50 hours of operation.
Use only
a 10 micron
hydraulic
filter. Order part number
723-0405.
Flexible Pump Coupler
The flexible
pump
coupler
is a nylon "spider"
insert, located
between
the pump
and the engine shaft. Over time, the coupler
will harden and deteriorate.
If you detect vibration
or noise
coming
from the area between
the engine
and the pump contact
an authorized
service dealer. If the coupler
fails completely,
you
will experience
a loss of power.
Hydraulic Fluid
Check the hydraulic
fluid level in the log splitter
reservoir
tank before each use. Maintain
the fluid level within
the range
specified
on the dipstick
at all times.
Change the hydraulic
fluid in the reservoir
every 100 hours of
operation.
Follow the steps below:
1.
Disconnect
the suction
hose from the bottom
of the
reservoir
tank.
Carefully
unthread
the inlet filter and clean it with
penetrating
oil. See Fig. 6-1.
i
Suction Hose
Figure 64
J
3.
Allow the fluid to drain into a suitable
container.
4_
NOTE:The
reservoir
tank has a capacity of 3 gallons and
the entire
hydraulic
system has a capacity of approximately
4.7 gallons.
Check the fluid level using the dipstick.
Do not overfill.
NOTE:Approved
fluids include
Shell Tellus ®32 Hydraulic
Fluid, Dexron ® III / Mercon ®automatic
transmission
fluid,
Pro-Select T_AW-32 Hydraulic
Oil or IOWAW-ISO viscosity
grade 32 hydraulic
oil. It is not recommended
that fluids be
mixed.
5.
Replace the vented dipstick
securely, tightening
it until the
top of the threads are flush with top of the pipe.
6.
Disconnect
the spark plug and prime the pump
by pulling
the recoil starter as far as it will go. Repeat approximately
10 times.
7.
Reconnect
the spark plug wire and start the engine
following
the instructions
in the Operation
Section.
8.
Use the control
handle to engage
the wedge
to the farthest
extended
position.
Then retract the wedge.

Publicidad

loading

Este manual también es adecuado para:

570 serie