Craftsman 917.773753 Manual De Instrucciones página 13

_,WARNmNG: To avoid serious injury,
before performing any service and
adjustments:
1. Stop engine.
2. Make sure the rotating lines and all
moving parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come in
contact with plug.
TO ADJUST TRI_MmNG HEmGHT
See "TO ADJUST TRIMMING HEIGHT" in
the Operation section of this manual.
TO ADJUST HANDLE
The upper handle may be adjusted to dif-
ferent height positions.
* Loosen handle knob only enough to
allow the upper handle to pivot to the
desired position.
* Tighten handle knob securely.
NOTE: The handle knob and bolt may be
reversed for left handed operation.
II
,/
TO REI\,_OVE/BEPLACE TBmI\,_MEB HEAD
DBmVE BELT
1. Remove screw at front of chassis cover.
2. Lift cover up and away from trimmer.
3. Remove the two (2) screws on sides of
Chassis
COVe[
trimmer securing the debris shield.
4. Turn trimmer on its side with carburetor
and fuel cap up.
5. Remove the two (2) screws on under-
side of trimmer securing the debris
shield.
6. Slide the debris shield rearward and
remove.
7. Remove belt from engine pulley on
crankshaft.
gine
pulley
Handle knob
13