Craftsman Evolv 113.175550 Manual Del Propietário página 5

Assembly (continued)
Caster/Caster Foot Assembly
1. Remove the powerhead assembly from
the dust drum and set aside.
2. Turn the dust drum upside down on the
floor.
3. Insert the caster feet into the bottom of
drum, as shown (4 places).
4. Push on the caster foot until the foot is
flush with bottom of the dust drum.
5. Insert the caster stem into the socket of
the caster foot, as shown (4 places).
6. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
7. Turn the drum upright.
Caster
Caster Stem
Caster Ball
Pin >
Foot
Drum
Vac Assembly
1. Line up front of powerhead assembly
with Vacuum port located on the front
of the drum.
NOTE: Powerhead assembly must be
aligned with drum for proper attachment.
2. Place powerhead assembly on top of
drum.
3. Be sure powerhead assembly
completely covers the top of the drum
so leakage does not occur.
Powerhead
Assembl
Push Down
and Pull Out
Flexible
Locking Tab
(located
under latch)
Vacuum Port
4. Push down on top of handles to cause
flexible locking tabs to hook onto the
drum lip.
5. Make sure that the locking tabs are
snapped into place to prevent the lid
from coming off (see detail below).
6. To remove the powerhead assembly,
reverse above directions.
Flexible Locking
Tab Pulled Out
/
Flexible _4 J
Locking Tab/_'; i ; ._"
Powerhead
Assembl'
Push Down
and Pull Out
Flexible
Locking Tab
(located
under latch)
I I