Publicidad
Idiomas disponibles
Idiomas disponibles
6. Turn knob clockwise
to secure el-
bow tube.
VACUUM
TUBE ASSEMBLY
_ILWARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum inlet
door or attempting to insert or remove
the vacuum or blower tubes. The rotat-
ing blades can cause serious injury.
1. Insert the tip of a screwdriver
into
the latch area of the vacuum
inlet.
I CatCh Area
Blower
Vacuum
Inlet Cover
2.
Gently tilt the handle of the screw-
driver toward the front of the unit to
release the latch while pulling up
on the vacuum
inlet cover with your
other hand.
3.
Hold the vacuum
inlet cover open
until upper vacuum tube is installed.
Vacuum
Inlet
Cover
4,
Inlet
Align the tabs on the inside of the
vacuum
inlet with the slots in the
upper vacuum
tube.
/
Tab
Slot
5. Push the upper vacuum tube into
the vacuum
inlet. Turn the tube
counterclockwise
until a click is felt
to secure the tube to the blower unit.
6. Align slanted
end of lower vacuum
tube as shown. Firmly push lower
vacuum tube into upper vacuum
tube.
S,
Slanted
of
lower vacuum tube
--
_,--
HOW TO CONVERT
UNIT FROM
VACUUM
USE TO BLOWER
USE
1. Remove the elbow tube and vacu-
um bag by turning the knob coun-
terclockwise
to loosen the elbow
tube.
2. Remove the vacuum
tubes by turn-
ing the tubes clockwise.
3. Close the vacuum
inlet cover and
make sure it is latched closed.
4. Reinstall the blower tubes (see
BLOWER TUBE ASSEMBLY).
VACUUM
BAG SHOULDER
STRAP
ADJUSTMENT
1. Hold the unit as shown
with the
muffler side facing away from your
body and clothes.
2. Pass the shoulder strap over your
head and onto your right shoulder.
3. Extend your left arm toward the
rear of the vacuum
bag.
4. Adjust shoulder strap until the vacu-
um bag/shoulder
strap seam lies be-
tween your thumb and index finger.
5. Make sure air flows freely from the
elbow tube into bag. If bag is
kinked, the unit will not operate
properly.
Publicidad
