HAMPTON BAY HSP2301LX-03/MB Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
A-Lamp Body x1
Assembly and Installation
1
Attaching and installing the light
WARNING: Never push the fixture into the ground by the lamp
body (A) or use a hammer to insert the ground stake (C) into the
ground.
Insert the fixture wire on the wire connector (B) into the groove
□
located on the top of the ground stake (C).
Screw the top of the ground stake (C) into the bottom of the lamp
□
body (A). Ensure the fixture wire on the wire connector (B) stays in the
center of the groove on top of the ground stake (C) to avoid damage to
the fixture wire.
Prepare a hole in the installation location. Use a tool such as a
□
screwdriver (sold separately) to prepare the installation hole to ensure
the hole is not larger than the ground stake (C).
Install the fixture in the ground by pushing on the foot step (1) on the
□
ground stake (C). Do not push on the lamp body (A).
The lamp body (A) can rotate up and down 130 degrees.
□
B–Wire Connector x1 (with 12 in.
wire attached to lamp body)
2
Connecting the wires
Place the wire connector (B) on opposite sides of the low voltage
□
cable (sold separately) from the transformer (sold separately)
where the fixture will be located.
Align and fit the main low voltage cable vertically to the slot of
□
the wire connector (B).
Press the wire connector (B) together until it is locked around the
□
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (B) is in place, it is recommended to
□
wrap it with electrical tape (sold separately).
After all fixtures are installed, turn on the transformer.
□
1
Model # HSP2301LX-03/MB
Model # HSP2301LX-03/ZC
Use and Care Guide
LED LOW VOLTAGE SPOT LIGHT
C – Ground Stake (6.693 in.) x1
WARNING: The wire connector (B) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION: The wire from the low voltage power unit should be
12-16 AWG type underground low Energy Circuit Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light
□
fitting, or next to a building structure such as a house or a
deck.
The landscape wire and connector can also be hidden under
□
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Item # 1009 033 778
Item # 1009 033 780