Descargar Imprimir esta página

BONAIRE DURANGO UCT30RWA Manual Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote Control Features and Settings
Remote Control
2
3
4
7
9
12
10
16
17
1. Power Button
Press the ON/OFF button on the remote control to start or
stop the unit.
2. Turbo/Quiet Button
The TURBO/Quiet function is used for fastest/slowest air
flow in Heating or Cooling modes. Control will display the
TURBO/QUIET icon [UP ARROW/DOWN ARROW] on
the bottom left/right side of the remote display. Pressing
the TURBO/QUIET button will enter the fastest mode
under heating or cooling mode, pressing the TURBO/
QUIET button again will enter the slowest mode under
heating or cooling mode, pressing the TURBO/QUIET
button or FAN SPEED button again will turn TURBO/
QUIET off, and the wind speed will return to the original
set value.
3. COOL Button
In COOL mode, the unit operates in cooling. When FAN
is set to AUTO, the air conditioner automatically adjusts
the fan speed according to the room temperature. The
will be displayed during COOL mode.
4
4. HEAT Button
In HEAT mode, warm air will blow out after a short period
of the time due to cold-air prevention function. When FAN
is set to AUTO, the heat pump automatically adjusts the
fan speed according to room temperature. The will be
displayed during HEAT mode.
5. DRY Button
DRY mode is used to reduce humidity. In DRY mode,
1
when room temperature becomes lower than temp.
setting +1°C, unit will run intermittently at LOW speed
regardless of FAN setting. The
5
DRY mode.
6. Temperature +/- Buttons
6
Temp + Every time the button is pressed, the temperature
8
setting increases.
Temp - Every time the button is pressed, temperature
setting decreases.
14
The operating temperature range is 60°F-86°F (16°C-30°C).
7. FAN SPEED Button
13
FAN SPEED: For each setting, press the fan speed
15
changes as follows:
Remote Control:
11
8. Louver Swing Button - UP/DOWN
18
Press the LOUVER UP/DOWN button to choose the
position of the horizontal airflow louvers.
Status display of air flow
COOL/DRY:
NOTE:
• It is advisable not to keep the vertical louver in the
downward position for an extended period of time in
COOL or DRY mode, otherwise condensate water may
form on the louver.
• When turning the unit on, the remote control will
automatically return the louver to the previous set swing
position. When turning the unit off, the louver will rotate
to the full open position prior to closing.
9. Louver SWING Button - SIDE/SIDE
Press the LOUVER SIDE/SIDE button to choose the
position of the vertical airflow louvers.
Status display of air flow
COOL/DRY
NOTE:
• When humidity levels are high, condensate water may
occur at the air outlet if all vertical louvers are adjusted
to far left or right.
will be displayed during

Publicidad

loading