Publicidad
Idiomas disponibles
Idiomas disponibles
ADD GASOLINE
• Fill fuel tank. Use fresh,
clean, regular
unleaded
gasoline with a minimum of
87 octane. Do not mix oil with gasoline.
Purchase fuel in quantities that can be
used within 30 days to assure fuel
freshness.
AWARNING:
Experience
indicates that
alcohol blended fuels (called gasohol or
using ethanol
or methanol)
can attract
moisture which leads to separation
and
formation
of acids during storage. Acidic
gas can damage
the fuel system of an
engine while in storage.
To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the fuel tank, start the
engine and let it run until fuel lines and
carburetor are empty. Use fresh fuel next
season.
See Storage
Instructions for
additional information.
Never use engine
or carburetor cleaner products in fuel tank
or permanent damage
may occur.
_CAUTION:
Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or use
gasoline near an open flame.
TO START ENGINE
NOTE:
Due to protective
coatings
on the
engine,
a small amount
of smoke
may be
present
during the initial use of the
product
and should
be considered
normal.
• To start a cold engine,
push primer
three (3) times before trying to start.
Use a firm push. This step is not usually
necessary
when starting
an engine
which has already
run for a few
minutes.
• Hold operator
presence
control
bar
down to the handle
and pull starter
handle
quickly.
Do not allow starter
rope to snap back.
• To stop engine,
release
operator
presence
control
bar.
NOTE:
In cooler weather
it may be
necessary
to repeat priming
steps. In
warmer
weather
over priming
may cause
flooding
and engine will not start. If you
do flood engine,
wait a few minutes
before attempting
to start and do not
repeat priming
steps.
Engine oil cap
Gasoline filler
P
8
Publicidad
