Publicidad
Idiomas disponibles
Idiomas disponibles
This charger is intended to recharge ProTeam Lithium Ion battery packs 107513, 107637,
and 107724. See website for additional battery pack and charger compatibilities.
WARNING
CHARGING PROTEAM LITHIUM ION BATTERY PACKS
Lithium Ion battery packs deliver fade-free power for their entire run time. The GoFree Flex Pro
vacuum will not gradually lose power due to decreasing battery pack charge. The vacuum will
perform at its normal performance level until the battery pack has been depleted. Once this
happens, recharging of the battery pack is required. It is not necessary to drain the battery pack
completely before recharging.
If none of the charger LEDs is lit at any point during the charging process, remove the battery
pack from the charger to avoid damaging the product. DO NOT insert another battery pack.
Contact ProTeam Customer Service with any issues.
BATTERY PACK PROTECTION FEATURES
ProTeam 36-volt Lithium Ion battery packs are designed with features that protect the Lithium Ion
cells and maximize battery pack life. When the battery pack has reached its minimum voltage
level the electronics will shut off the battery pack. Once the battery pack shuts off, it must be
recharged.
PREPARING BATTERY PACK FOR
CHARGING
1. Plug the charger's power cord into the
charger (Figure A).
2. Install battery pack on charger as
shown (Figure B) and lock in position
by turning knob clockwise.
3. Plug the charger's power cord into
120V (230 V for Europe) wall outlet
(Figure C).
4. The left indicator light should turn Red.
The right indicator light will flash Green
when charging and will stop flashing
and remain Green when fully charged
(Figure D). The battery pack will require
approximately 3 hrs (12.8Ah) to fully
charge.
Note: Prior to charging, the battery
pack may be in standby mode for
approximately an additional hour to allow
cooling.
5. Verify the charge level of the battery
pack by pressing the power level
indicator button on the front of the
pack. (Figure E). Five Red lights
indicate a fully charged battery pack.
Remove battery pack from charger
and unplug cord from wall outlet after
charging.
4
O P E R A T I O N
I N T R O D U C T I O N
Charge in a well-ventilated area. DO NOT block charger
vents. Keep them clear to allow proper ventilation.
Figure A
Figure C
Figure E
*Battery pack may get warm while charging.
ProTeam Owner's Manual
Figure B
Figure D
Publicidad
