Schwaiger CAT 8.1 Instrucciones De Instalación página 3

MOUNTING INSTRUCTIONS
For RJ45 plugs, metal, without tools
Suitable for network cables from Ø 6 mm up to max.
8 mm if the cable outer sheath should reach below the
strain relief, otherwise up to 9.5 mm.
2
3
4. Disentangle the wire pairs. Make sure it remains clear which wires belong together as a
pair, so the wires can be connected correctly later (the connector block
with the colours for TIA/EIA T568A and B). Insert the wires in the corresponding recess-
es
of the connector block.
6
7
8
1
Please
NWKU80xx 051.
1
1. Remove the screw socket
mounting.
2. Feed the cable through the screw socket in the specified
direction and remove the outer sheath
over a length of approx. 20-25 mm. Fold back the braid
(and if necessary, the drain wire).
4
5
6
5
use the Schwaiger
TIA/EIA
T568A
1 white/green white/orange
2 green
3 white/orange white/green
4 blue
5 white/blue
6 orange
7 white/brown white/brown
8 brown
network
(= strain relief) before
1
of the cable
2
3. For S/FTP cables, remove
the foil shield
surrounds each wire pair.
If there is a yarn strength
member in the middle
4
of the cable, remove it.
is marked
5
Cut the protruding ends
of the wires
7
suitable tool.
5. Press the prepared con-
nector block
actual plug housing
until it stops. This can only
be done in one position;
you cannot slide the block
incorrectly into the plug
housing.
6. Close the plug housing (if
necessary, with the help
of suitable pliers) and
screw the screw socket
/ strain relief
plug housing.
TIA/EIA
T568B
orange
blue
white/blue
green
brown
cable
which
3
with a
into the
5
8
to the
1