Publicidad
Idiomas disponibles
Idiomas disponibles
Handle Column
.- Handle Assembly
"UP" Position
Loosen Handle Lock
Lever to Move
Tighten handle
_, lock lever to hold
4. Insert pivot bolt in front part of plate
and tighten.
5. Cut down remaining corners of carton
and lay panels flat.
6. Lower the handle assembly. Tighten
nut on carriage bolt so handle moves
with some resistance.
This will allow
for easier adjustment.
7. Place flat washer on threaded end of
handle lock lever.
8. Insert handle lock lever through handle
base and gearcase.
Screw in handle
lock lever just enough to hold lever in
place.
9. Insert second handle lock (with teeth
inward) in the slot of the handle base
(just inside of washer).
10. Raise handle assembly to highest
position and securely tighten handle
lock lever by rotating clockwise.
Leav-
ing handle assembly in highest position
will make it easier to connect shift rod.
Flat Washer
Handle Lock
Lever
Slot
Rear Cartridge
Bolt
Pivot Bolt
Handle Base
INSERT CABLE CLIP
• Insert plastic cable clip into hole on the
back of handle column.
Push cables
into clip.
Cables
Cable Clip
handles
14
CONNECT
SHIFT
ROD
1.
Insert
end of shift rod farthest
from
bend into hole of shift lever indicator.
2.
Insert
hairpin
clip through
hole of shift
rod to secure
with bend of clip on right
side.
0-"_ Attach this End To shift
Shift Rod
Lever Indicator
Shift Lever
Hairpin Clip
_dicator
Shift Rod
7
REMOVE
TILLER
FROM
CRATE
1. Adjust handle assemby to lowest
position. Be sure lock lever is tightened
securely.
2. Make sure shift lever indicator is in "N"
(neutral) position.
3. Tilt tiller forward by lifting handle. Sep-
arate cardboard cover from leveling
shield.
4. Rotate tiller handle to the right and pull
tiller out of carton.
CHECKTIRE
PRESSURE
The tires on your unit were overinflated at
the factory for shipping purposes.
Correct
and equal tire pressure is important for
best tilling performance.
• Reduce tire pressure to 20 PSI.
HANDLE
HEIGHT
• Handle height may be adjusted to bet-
ter suit operator.
(See "TO ADJUST
HANDLE HEIGHT"
in the Service and
Adjustments
section of this manual).
Publicidad
