Legend Brands Dri-Eaz DefendAir 400 Manual Del Propietário

DefendAir
Legend Brands, Inc., 15180 Josh Wilson Rd., Burlington, WA 98233 | 800-932-3030 | LegendBrands.com
The DefendAir 400 removes airborne particles such as dust, mold spores, pollen, pet dander and other debris.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING
WARNING! Do not alter or modify your unit in any way.
Use only replacement parts authorized by Legend Brands.
Modifications or use of unapproved parts could create a
hazard and will void your warranty. Contact your
authorized Legend Brands distributor for assistance.
WARNING! Electric shock hazard, rotating fan,
hot surface hazards. Unplug unit before opening
cover for cleaning or servicing. Unit must be
grounded.
•
Inspect the power cord before use. If cord is damaged, do
not use. Always grasp the plug (not the cord) to unplug.
•
Plug cord into an electrically grounded outlet. Do not use
adapter. Never cut off ground prong. Do not use an
extension cord.
•
If the power cord is damaged, it must be replaced by a
Legend Brands authorized service center or similarly
qualified persons in order to avoid a hazard.
WARNING
a) Do not operate any fan with a damaged cord or plug.
Discard fan or return to an authorized service facility for
examination and/or repair.
b) Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route cord
under furniture or appliances. Arrange cord away from traffic
area and where it will not be tripped over.
NOTICE! Because federal, provincial and local laws and
regulations have varying requirements for the application, testing
and general use of equipment on asbestos abatement projects,
Legend Brands cannot warrant the use of any product we
manufacture for asbestos abatement. Contractors performing
abatement work should evaluate tools, equipment and
procedures in light of their local regulatory requirements, and
comply with those requirements.
127307A_127312_DefendAir400
Owners Manual
®
400 HEPA Air Scrubber
Item #127312
WARNING: BREATHING HAZARD
the risk of backdrafting deadly carbon monoxide fumes.
CONTROLS AND OPERATION
Setup
1. Unwrap the cord completely.
2. Place with handle and control panel facing up.
3. Plug into a standard 115v outlet (2.2 amps required).
4. This unit produces approximately 400 CFM of filtered air.
Circuit breaker reset switch
The circuit breaker automatically shuts off the electrical supply
when an overload or short circuit is detected. If this occurs,
unplug any units plugged into the power outlet, check the
power cord for damage and ensure it is plugged into a properly
grounded outlet. Press the switch to reestablish power.
Change filter light
The change filter light (Fig. A) illuminates when the HEPA
filter needs to be changed. To replace the filter, see Fig. C.
Power Outlet
Daisy-chain up to 5 DefendAir 400 units. Do not exceed the
unit's maximum of 12 amps while off and 9.8 amps while on.
Ducting
The inlet can be ducted with 12-in. rigid ducting and the outlet
with either 12-in. rigid or layflat ducting. Do not exceed a
maximum ducting length of 15 ft. / 4.6 m on the inlet and 15 ft. /
4.6 m on the outlet.
Stacking for Storage, Transport, and Operation
Stack up to 3 high for storage or operation, fitting the handle
of one into the bottom of a second unit. For compact storage,
stack horizontally. Be sure to secure properly for transport.
When using the DefendAir 400 in a containment
area, turn off all sources of power to open
combustion appliances such as fireplaces, boilers,
furnaces, water heaters and HVAC systems to avoid
Air movement
Static pressure
(H O)
2
Circuit maximum
Dimensions
(D × W × H)
Weight
Power
Power cord length
Housing
Safety
Specifications are subject to change without
notice. Some values may be approximate.
400 CFM
2.63 in.
4 addl. units (5 total)
22.9 × 17.7 × 21.7 in.
58.2 × 45.0 × 55.1 cm
29 lbs. | 13.2 kg
2.16A, 115V, 60 Hz, 215W
16 ft. | 4.9 m
Rotomolded polyethylene
ETL tested to UL
standards
Legend Brands, Inc.