Publicidad
Idiomas disponibles
Idiomas disponibles
After Use
After you have finished taking pictures, follow the steps below.
1
Submerge the Case in fresh water for about 30 minutes or more
without removing the digital camera to remove any salt crystals etc.
≥
Press all the operation buttons etc. on the Case to wash away any
seawater. If the salt crystals are not removed from the buttons etc., they
will harden and the buttons will become inoperable.
≥
Do not wash the Case with fast-running or pressurized water etc. as it may
cause water leakage.
2
Wipe the water with a dry cloth that has no salt crystals sticking to it
and then dry the Case completely.
≥
Do not dry the Case by exposing it to direct sunlight. This may discolor or
damage the Case or may hasten deterioration of the O-ring.
3
Open the rear of the case to remove the digital camera.
4
Remove the O-ring from the Case and check that there is no dirt etc.
in the O-ring groove.
5
Check that there are no scratches etc. on the O-ring while you are
applying the grease.
20
VQT2N71
Publicidad
