Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting(continued
Burner(s) will not light
using ignitor.
(See Electronic Ignition
Troubleshooting also)
Burner(s) w illnot match
light.
ELECTRONIC IGNITION:
• No spark, no ignition noise.
• No spark, some ignition noise.
• Sparks, but not at electrode or at full
strength.
• See "GAS ISSUES:" on previous page.
• Match will not reach.
• Improper method of match-lighting.
• See Section I of Electronic Ignition System.
• See Section II of Electronic Ignition System.
• See Section III of Electronic Ignition System.
• Uselong-stem match(fireplace match).
•See "Match-Lighting" sectionof Useand Care.
Sudden drop in gas
• Out of gas.
• Check for gas in LP cylinder.
flow or low flame.
•Turn off knobs, wait 30 seconds and light grill. If flames are still low,
• Excess flow valve tripped,
turn off knobs and LP cylinder valve. Disconnect regulator.
Reconnect regulator and leak-test. Turn on LP cylinder valve, wait
30 seconds and then light grill.
• Vapor lock at coupling nut/LP cylinder
•Turn off knobs and LP cylinder valve. Disconnect coupling nut from
connection,
cylinder. Reconnect and retry.
Flamesblowout.
Flare-up.
• High or gusting winds.
• Low on LP gas.
• Excess flow valve tripped.
• Grease buildup.
• Excessive fat in meat.
• Excessive cooking temperature.
• Turn front of grill to face wind or increase flame height.
• Refill LP cylinder.
• Refer to "Sudden drop in gas flow" above.
• Clean burners and inside of grill/firebox.
• Trim fat from meat before grilling.
• Adjust (lower) temperature accordingly.
Persistent grease fire.
Flashback...
(firein burnertube(s)).
• Grease trapped by food buildup around
burner system.
• Burner and/or burner tubes are blocked.
•Turn knobs to OFF. Turn gas off at LP cylinder. Leave lid in position
and let fire burn out. After grill cools, remove and clean all parts.
• Turn knobs to OFF. Clean burner and/or burner tubes. See burner
cleaning section of Use and Care.
Unable to fill LP
• Some dealers have older fill nozzles
• The worn nozzles don't have enough "bite" to engage the valve. Try
cylinder,
with worn threads,
a second LP dealer.
One burner does
• Grease buildup or food particles in end(s)
• Clean carry-over tube(s) with wire brush.
not light from other
of carryover tube(s).
burner(s).
24, 146.23770310
Publicidad
