Beam Q Manual Del Equipo página 5

POWERBRUSH PARTS IDENTIFICATION
Height Adjustment LED Indicator
LED Lights
ASSEMBLY & OPERATING INSTRUCTIONS FOR THE POWERBRUSH
When using the powerbrush, the basic precautions outlined under "IMPORTANT SAFETY
INSTRUCTIONS" should always be followed.
1. Push the wand into the powerbrush socket until it locks in place. The wand
socket is designed with a positive stop. Therefore, the wand will not jam
in the wand socket. Insert hose end into the powerbrush wand on the
assembled powerbrush until is locks in place. (figure 3)
2. Make sure the hose handle powerbrush button is in the OFF position.
3. Insert the hose into the wall inlet valve (faceplate), and plug the cord into the
electrical outlet. (figure 4)
4. Lower the wand from the upright position using the Handle Release Pedal
on the powerbrush.
5. To turn the central vacuum power unit ON, push the +/- slide control
button forward on the hose handle. To turn the central vacuum OFF,
slide the control button toward you to the off position.
6. Variable speed slide control allows you to vary the suction power.
Press (+/-) slide control button and slide forward from the off
position. You will have several positions to adjust the suction level.
7. To turn the powerbrush ON or OFF, press or depress the
powerbrush button symbol .
Height Adjustment Pedal Quick Release Neck
Circuit Breaker Indicator
(glows red in color for
a stalled or jammed
condition)
Handle Release Pedal
Figure 2.
Figure 3.
Figure 4.
5