Publicidad
Idiomas disponibles
Idiomas disponibles
CARBURETOR
Your carburetor
has a non-adjustable
fixed main jet for mixture control.
If your
engine
does
not operate
properly
due to
suspected
carburetor
problems,
take your
lawn mower to a Sears or other qualified
service
center
for repair and/or
adjust-
ment.
IMPORTANT:
Never tamper
with the
engine governor,
which is factory
set for
proper engine speed.
Overspeeding
the
engine above the factory
high speed
setting can be dangerous.
If you think the
engine-governed
high speed
needs
adjusting, contact a Sears or other
qualified service
center, which has proper
equipment
and experience
to make any
necessary
adjustments.
Immediately
prepare
your lawn mower
for
storage
at the end of the season
or if the
unit will not be used for 30 days or more.
LAWN
MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease,
leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
section of this manual).
2.
Lubricate as shown in the Mainte-
nance
section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if
necessary.
4.
Touch
up all rusted or chipped
paint
surfaces;
sand lightly before
painting.
HANDLE
You can fold your lawn mower
handle for
storage.
1. Squeeze
the bottom
ends of the lower
handle
toward
each other
until the
lower
handle
clears
the handle
bracket,
then move handle
forward.
2.
Loosen
upper
handle
mounting
bolts
enough
to allow
upper handle
to be
folded
back.
IMPORTANT:
When folding
the handle
for storage
or transportation,
be sure to
fold the handle as shown
or you may
damage
the control
cables.
• When setting
up your handle from the
storage
position,
the lower
handle
will
automatically
lock into the mowing
position.
SQUEEZE
TO FOLD
Operator I
control bar
Lower
FOLD
BACKWARD
g
position
ENGINE
FUELSYSTEM
IMPORTANT:
Itis important
to prevent
gum deposits
from forming
in essential
fuel system
parts such as carburetor,
fuel
filter, fuel hose, or tank during storage.
Also, alcohol
blended
fuels
(called
gasohol
or using
ethanol
or methanol)
can attract
moisture
which leads to
separation
and formation
of acids during
storage.
Acidic gas can damage
the fuel
system
of an engine
while in storage.
1. Drain the fuel tank.
2.
Start the engine
and let it run until the
fuel lines and carburetor
are empty.
15
Publicidad
