Arenti P2Q Guia De Inicio Rapido página 6

support@arenti.com
Pairing
Open APP home page, Click "+" or "Add" and select icon
according to actual camera.
Power on the device. For about 30 seconds, the camera will
emit start-up tone and LED indicator will flash red slowly.
Note: When pairing, please put the camera and mobile phone close
to the router. If camera is not in the red slow blinking after 30
seconds of powering on, press and hold the reset button for 5
seconds to reset, and then configure the network again.
Select the Wi-Fi network and input the password, and then
click "Next". Make sure that your phone has connected to a
fluent and steady Wi-Fi already.
EN