Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Ifshield isnot p roperly installed,
damage tounit ( including
motor failure)
will r esult.
1=Align t heinstallation
arrow onthe
shield w ith the installation
arrow on
themotor housing (see illustration
below).
2=Insert theshield o nto the motor
housing. Ensure the cutting head
remains free torotate a nd the line
isnot c aught between the shield
and the motor housing.
3. Twist the shield a sillustrated
until
itsnaps s ecurely into place. Make
sure the shield i sassembled
tothe
unit a sshown intheillustration
be-
low and intheKNOW
YOUR UNIT
section ofthis manual.
ALIGN
I NSTALLATION
ARROWS
Twist shield
in direction
of
arrow to
assemble
CAUTION:
Sharp line Iimiter blade
KNOW YOUR TRIMMER
READ THiS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the vari-
ous controls and adjustments. Save this manual for future reference.
ar Switch
Cord
Retainer
Recessed
Plug
Locking
Sleeve
Assembly
Air
Vents
Debris Shield
RECESSED
PLUG
The RECESSED PLUG is where you at-
tach your extension
cord to the unit.
TRIGGER
SWITCH
The TRIGGER SWITCH is used to turn on
the unit. Squeeze
the trigger switch to
operate the unit. Release to stop.
LINE LIMITER
BLADE
The LINE LIMITER BLADE cuts the cut-
ting line to the proper cutting length.
Motor Housing
-nmmer Head
with 0,065 in,
Trimmer
Line
Tap Button
Line Limiter Blade
ASSIST
HANDLE
The ASSIST HANDLE is used to help hold
and guide the unit.
TRIMMER
HEAD
The TRIMMER HEAD holds cutting
line
and rotates during operation.
TAP BUTTON
The TAP BUTTON is used to advance the
cutting
line during operation
and to re-
move
the spool
during
line replace-
ment.
6
Publicidad
