Publicidad
Idiomas disponibles
Idiomas disponibles
5=Pull starter rope handle sharply until
engine runs.
6=Once t he engine starts, allow itto
run amaximum
of10seconds at
FULL CHOKE.
Then, slowly move
thered choke l ever tothe HALF
CHOKE
position.
7=Allow the unit t orunaminimum
of
20more s econds atHALF CHOKE
(colder temperatures
may require
longer warm-up periods before
theengine will a ccept aload and
accelerate
properly).
8=Move r ed choke lever toOFF
CHOKE
position and allow the unit to
run aminimum
of20more s econds
atOFF C HOKE.
Release
the throttle
trigger.
STARTING
ENGINE
NOTE:
Check oil level before starting.
Oil level should be at the FULL mark
on the dipstick.
If not, add oil (see
ADD OIL section).
1. Set unit on a flat surface.
2.
Slowly press the primer bulb 8
times.
3= Move red choke lever to FULL
CHOKE position.
4= Squeeze the throttle trigger fully and
hold through all remaining steps.
5= Pull starter rope handle sharply until
engine runs.
6= Once the engine starts, allow it to
run a maximum
of 10 seconds
at
FULL CHOKE. Then, slowly move
the red choke lever to the HALF
CHOKE position.
7= Allow the unit to run a minimum
of
20 more seconds at HALF CHOKE
(colder temperatures
may require
longer warm-up
periods before
the engine will accept a load and
accelerate
properly).
8= Move red choke lever to OFF
CHOKE position and allow the unit to
run a minimum of 20 more seconds
at OFF CHOKE. Release the throttle
trigger.
RESTARTING
A WARM ENGINE
Follow steps listed in the STARTING
ENGINE section without squeezing
throttle trigger.
If the unit will not start, refer to the
TROUBLESHOOTING TABLE or call
1-800-235-5878.
CRAFTSMAN
®
CONVERTIBLE
TM
FEATURE
This model is equipped with a coupler
which enables
optional attachments
to
be installed.
The optional
attach-
ments are:
Edger ...............
358.792403
Cultivator
............
358.792410
Blower
..............
358.792421
Brusbcutter
..........
358.792443
Pruner
..............
358=792450
AO&WARNING:
Always stop unit
and disconnect
spark plug before re-
moving or installing attachments.
REMOVING
TRIMMER
ATTACH-
MENT (OR OTHER OPTIONAL
AT-
TACHMENTS)
CAUTION:
When removing or instal-
ling attachments,
place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Upper Shaft
Coupler
Lower
\
Attachment
TIGHTEN
Knob
2.
Press
and hold
the locking/release
button.
Locking/Release
Button
Upper Shaft
Attachment
3.
While securely holding the engine
and upper shaft, pull the attach-
ment straight out of the coupler=
INSTALLING
OPTIONAL
ATTACHMENTS
1. Remove the shaft cap from the at-
tachment
(if present).
2.
Position locking/release
button of
attachment
into guide recess of
coupler.
3.
Push the attachment
into the cou-
pler until the locking/release
button
snaps into the primary hole.
4.
Before using the unit, tighten the
knob securely by turning clockwise=
Coupler
Primary Hole
Guide Recess
13
Upper
Locking/
Shaft
Release
Button
Attachment
Publicidad
