Descargar Imprimir esta página

Craftsman 917.294250 Manual De Instrucciones página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

• To maintain the superb tilling perfor-
mance of this machine the tines should
be checked for sharpness, wear, and
bending, particularly the tines which
are next to the transmission.
If the gap
between the tines exceeds 3-1/2 inches
they should be replaced or straightened
as necessary.
• New tines should be assembled. Sharp-
ened tine edges will rotate rear
3-1/2" Max
_
,_
Counter Tine
Rotation
Hairpin Clip
Hairpin Clip
Sharp Edge
J
Sharp Edge
Shear Pin
Sharp Edges
Shear Pin
tine 13
ENGINE
Maintenance,
repair, or replacement of
the emission control devices and systems,
which are being done at the customers ex-
pense, may be performed by any non-road
engine repair establishment
or individual.
Warranty repairs must be performed by an
authorized engine manufacturer's
service
outlet.
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary.
However, engine performance
can be affected by differences in fuel, tem-
perature, altitude or load. If the carburetor
does need adjustment, contact your near-
est Sears or other qualified service center.
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact your nearest Sears or
other qualified service center which has
the proper equipment and experience to
make any necessary adjustments.
17

Publicidad

loading