Craftsman 358.341151 Manual De Instrucciones página 7

KNOW Y OUR
S AW
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the
location of the various controls and adjustments. Save this manual for future ref-
erence.
Oiler Actuator/ Chain Adjustment Bar Sprocket
Bar Oil Cap Screw Hole
Lock-out
Button _
Chain
Bar
Trigger Switch
Power Cord
TRIGGER SWITCH
The TRIGGER SWITCH is used to turn
on the unit. Squeeze the trigger switch
to operate the unit after lock-out
button has been pushed in. Release
the trigger to turn the unit off.
TRIGGER LOCK-OUT BUTTON
The TRIGGER LOCK-OUT BUTTON is a
control feature designed to prevent the
motor from being accidently started.
When the rear handle is gripped in a
normal cutting position, the trigger
lock-out button can be pushed in by
the thumb, permitting the index finger
to squeeze the trigger. It is not neces-
sary to maintain pressure on the trig-
ger lock-out button once the trigger
has been engaged.
BAR OIL CAP/OILER ACTUATOR
The BAR OIL CAP is used to access the
bar oil tank and pressed to supply oil
to chain.
CHAIN ADJUSTMENT SCREW
The CHAIN ADJUSTMENT SCREW is
used to adjust the chain tension.
POWER CORD
The POWER CORD is used to connect
the chain saw to an approved exten-
sion cord.
CHAIN TENSION
It is normal for a new chain to stretch
during first 15 minutes of operation.
You should check your chain tension
frequently. Readjust chain after every
15 minutes of operation.See CHECK
CHAIN TENSION under the SERVICE
AND ADJUSTMENTS section.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified
on your unit.
SELECT AN EXTENSION CORD
Extension cords are available for this
unit at Sears.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
25 if, 50 ft. 1O0 ft.
Volts
(7.67 m) (15.24 m) (30.48 m)
16 16 14
120 A.W.G.* A.W.G.* A.W.G.*
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection from unit, se-
cure extension cord to power cord as
shown in the following illustration.
*American Wire Gauge