Troy-Bilt 020240 Manual De Instrucciones página 18

TROU B LES H OOTi NG
Probmem
Pump has following problems:
faimure to produce pressure, erratic
pressure_ chattering_ moss of
pressure_ mow water vomume.
Detergent falls to mix with spray°
Engine runs good at no-load but
"bogs _' when moad is added.
Pressure washer stops during
operation°
Cause
I. Low pressure nozzle installed.
2. VVater inlet is blocked.
3. Inadequate water supply.
4. Inlet hose is kinked or leaking.
5. Closed inlet hose strainer.
6.
VVater supply is over 100°E
7. High pressure hose is blocked or
leaks.
8. Gun leaks.
9. Nozzle is obstructed.
I0. Pump is faulty.
I. Detergent siphoning tube is not
submerged.
2. Chemical filter is cloged or
cracked.
3. Dirty inoline filter.
4. High pressure nozzle installed.
Engine speed is too slow.
Out of fuel.
Correction
I. Replace nozzle with high pressure
nozzle.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose
strainer.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replace gun.
9. Clean nozzle.
i0. Contact authorized service facility.
I. Insert detergent siphoning tube
into detergent.
2. Clean or replace filter/detergent
siphoning tube.
3. See "Check In-Line Filter".
4. Rephce nozzle with low pressure
nozzle.
Move throttle control to FAST
_osition. If engine still "bogs down",
sontact Brigs and Stratton service
facilit 7.
Fill fuel tank.
4@